Specify switch/IDF height

Comments: 11

Oldest • Newest • Most likes • Fewest likes

• Add a comment
• 26 Sep, '25
  Joel Crane System

  Highlighted comment
  
  "MDF/IDF - Switch height" (suggested by <Hidden> on 2025-09-25), including upvotes (1) and comments (0), was merged into this suggestion.

  Copy link to this comment
• 27 Mar, '24
  JB

  Applies to my use case as well. Often have remote IDFs that are little more than a hoffman box, mounted 30 feet in the air to the steel beam.

  Copy link to this comment
• 06 Apr, '24
  Vasileios Merged

  It would be great if you could set the network equipment (e.g. IDF) height in the floor plan and visualise it.
  
  I realised it would be handy after I tried to "mount" an IDF in the Catwalk and it ended up in the middle of the court :D

  Copy link to this comment
• 08 Apr, '24
  Joel Crane System

  "Add Network Equipment Height" (suggested by <Hidden> on 2024-04-06), including upvotes (1) and comments (0), was merged into this suggestion.

  Copy link to this comment
• 19 Dec, '24
  Alan B Merged

  Specify the height of an IDF/Switch to support accurate cable length measurements, same way as you would for an AP

  Copy link to this comment
• 20 Dec, '24
  Joel Crane System

  "Specify height of IDF/Switches" (suggested by <Hidden> on 2024-12-19), including upvotes (1) and comments (0), was merged into this suggestion.

  Copy link to this comment
• 08 Apr, '25
  VS Merged

  Need to have the ability to put the height of an IDF. For example, my potential customer IDF is 25 feet up, and ceilings are 50 feet.

  Copy link to this comment
• 18 Jul, '25
  Joel Crane System

  "Configurable Switch, IDF, and MDF height" (suggested by <Hidden> on 2025-04-08), including upvotes (1) and comments (0), was merged into this suggestion.

  Copy link to this comment
• 18 Jul, '25
  Joel Crane Admin

  I personally think that we need to do this for PoE clients as well - make them both behave exactly like APs when it comes to height settings and cable calculations.

  Copy link to this comment
• 20 Jul, '25
  Matthew Zacune

  Being able to specify the height of switches/IDFs as well as wired clients and ceiling height to be able to account for the vertical part of cable runs. This is espeically important in facilities with high ceilings like warehouses.

  Copy link to this comment
• 25 Sep, '25
  mali@mspwireless.com Merged

  At times in warehousing and manufacturing environments IDF's(switches are installed higher up. This impacts the cable length. Would like an ability to specify closet/switch heigh.

  Copy link to this comment